Supply & Fit
A powder-coated aluminium gate with full automation, fitted and tested in a single visit.
What Goes Wrong
The material is straightforward, the mistakes come from skipping the steps that make automation work long-term.
A motor specified without knowing the gate leaf weight will strain on every cycle and fail within a few years.
Aluminium’s consistent leaf weight lets the motor be correctly sized before ordering, not guessed on the day.
Gates handed over without a full opening and closing cycle test often develop alignment faults within weeks of use.
A complete opening and closing cycle test confirms motor response, sensor clearance, and remote range before handover.
Fitting swing gates where there is no arc space, or sliding gates with no run-back, creates an entrance that barely works.
A site survey confirms driveway layout and available space before swing or sliding is recommended, not assumed.
A gate fitted adjacent to a highway without checking consent can require removal or costly retrospective applications.
Planning considerations are identified during the survey, so the gate design accounts for any height or boundary constraints.
Scope of Work
From gate leaves and motor to sensors and remote handsets, everything is sourced and fitted as one coordinated job.
Gate leaves hung on manufacturer-specified hinges with a motor and control panel set to the correct arc and force limits.
A sliding configuration fitted where driveway run-back allows, with track, motor, and safety sensors aligned on site.
Motor, control box, safety sensors, and remote handsets supplied and wired as part of the same installation visit.
Gate leaves arrive with the powder-coat already applied and are checked for surface condition before handover.
Leaf alignment confirmed to manufacturer tolerance.
Handsets paired and range-tested on site.
Photocells and safety edges fitted to DHF spec.
Control box wired and programmed before handover.
Why Choose Us
Local installers who know Brentwood driveways, specified to Gate Safe and DHF standards on every job.
Every installation is specified and fitted to Gate Safe standards, covering force limits and safety device placement.
Safety edges and photocells are specified to DHF standards as standard, not an optional add-on at extra cost.
A local installer surveys the entrance first, so the quote reflects the actual groundwork, wiring, and gate size needed.
Gate leaves, motor, sensors, and handsets are all sourced and fitted in one coordinated visit, reducing disruption.
Swing or sliding is confirmed on site after measuring arc space and run-back, not decided from a phone call.
How It Works
01
Share the gate width, driveway slope, and power supply location so the right installer can be arranged for your area.
02
A local installer visits to confirm configuration, groundwork needs, and wiring route before providing a full written quote.
03
Gate leaves, motor, sensors, and handsets are fitted and a full opening and closing cycle test is completed on site.
Pricing Estimates
| Job | Typical cost |
|---|---|
| Basic aluminium gate installation | £3000-£8000 |
| Mid-range aluminium gate installation | £5000-£10000 |
| Bespoke aluminium gate installation | £10000-£20000 |
Describe the gate width, slope, and power supply and we’ll arrange a local installer to survey and quote the full job.