Wrought Iron & Metal Gates Questions

No. What is supplied is mild steel with electro-galvanising and a powder-coated finish. This gives the same decorative appearance as traditional wrought iron but with better rust resistance and a more consistent colour. True forged wrought iron is rarely fabricated today.

If the opening is an unusual width, the ground is uneven, or the property has an older frame, made-to-measure is the safer choice. Standard sizes often leave gaps at the posts or sit too high off the ground, which affects both appearance and how well the gate closes.

A gate that does not close flush or latch properly gives no real security. Rust that starts at a scratch or weld point spreads under the powder coat and weakens the frame over time. Replacing a structurally sound gate is cheaper than replacing one that has corroded through.

Measure the opening width and height, decide whether you need single or double leaves, and check whether existing posts, hinges, and a latch are reusable. Also confirm the ground is level enough for the gate to swing clear without dragging.

It is possible for simple, lightweight openings. For heavier or wider gates, the posts need to be set in concrete at the correct depth and the hinges aligned precisely. Getting either wrong means the gate binds, sags, or pulls the post out of plumb within a season.

Wash it down periodically and touch up any chips with a compatible primer and topcoat before rust takes hold beneath the surface. The electro-galvanised layer provides a second line of defence, but surface damage left untreated will eventually reach the steel.